Selecting a point of interest using the map
You can select points of interest that are available in the selected (visible) section of the map.
To activate navigation mode: press the
function button once or twice.
To show the menu: press 
the COMAND
controller.
1 Highlighted point of interest
Slide 
the COMAND controller
forwards
and thereby activate the display window.
The map with highlighted point of interest 1 is shown.
To highlight the next point of interest: select Next in the menu bar by
turning
and sliding 
the COMAND
controller and press to confirm.
To highlight the previous point of
interest: select Previous in the menu bar
by turning
and sliding 
the
COMAND controller and press to
confirm.
To display details of a point of interest: select Details in the menu
bar by turning
and sliding 
the COMAND
controller and press to confirm.
See also:
Problems with the rear window defroster
The rear window defroster has deactivated
itself prematurely or cannot be activated.
Switch off any consumers that
are not
required, e.g. reading lamps or interior
lighting.
When the batter ...
Windshield washer system and headlamp cleaning system
The washer fluid reservoir is used for both the
windshield washer system and the headlamp
cleaning system.
Vehicle components and their
service
products must match. You should,
therefore, ...
2011 Mercedes-Benz R-Class Review
As family-haulers go, the Mercedes-Benz R350 Bluetec is a nice rig — perhaps
too nice for the sippy-cup-and-Cheerios gang. Even though the R350 doesn't fit
nicely into a defined category such as m ...