Switching to navigation mode
Press the 
function button once
or
twice.
or
Select Navi in the main function bar by
sliding 
and turning
the COMAND
controller and press 
to confirm.
In both cases, you will see the map either
with or without the menu shown.
Map showing the menu; route guidance inactive
1 Current vehicle position
Map without the menu; route guidance inactive
1 Current vehicle position
2 Map orientation selected
3 Map scale selected
"Route guidance active" means that you have entered a destination and that COMAND has calculated the route. The display then shows the route, changes of direction and lane recommendations. Navigation announcements guide you to your destination.
"Route guidance inactive" means that no destination has been entered and that no route has been calculated.
See also:
Attaching the roof carrier
Attaching the roof carrier
Open covers 1 carefully in the
direction of
the arrow.
Fold covers 1 upwards.
Only secure the roof carrier to the
anchorage points under covers 1.
Observe th ...
Switching on/off
The three blue indicator lamps in the buttons
indicate the ventilation level you have
selected.
If the battery voltage is too low, the seat
ventilation may switch off.
Make sure that the S ...
Tachometer
The red band in the tachometer indicates the
engine's overrevving range.
Do not drive in the overrevving range, as
this could damage the engine.
The fuel supply is interrupted to protect th ...