Reset function
You can reset COMAND to the factory settings. Amongst other things, this will delete all personal data (e.g. station presets, address book entries, entries in the destination memory and in the list of previous destinations in the navigation system).
Resetting is recommended before selling or transferring ownership of your vehicle, for example.
Select Vehicle in the main function bar by
turning 
the COMAND controller and
press 
to confirm.
Select System by turning
the
COMAND controller and press to
confirm.
Select Reset and press to
confirm.
A prompt appears asking whether you wish
to reset.
Select Yes or No and press to
confirm.
If you select No, the process will be aborted.
If you select Yes, another prompt appears
asking whether you really wish to reset.
Select Yes or No and press to
confirm.
If you select Yes, a message will be shown.
COMAND is reset and restarted.
If you select No, the process will be aborted.
See also:
Important safety notes
The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
• corrosion protection
• antifreeze protection
• raising the boiling point
The engine coo ...
Editorial office
Not to be reprinted, translated or otherwise
reproduced, in whole or in part, without the
written permission of Daimler AG. ...
Tail lamp
Switch off the lights.
Open the trunk.
Open the side trim panel.
Remove the tail lamp connector
Simultaneously press retaining lugs
1 in the direction of the arrow and slightly pull out t ...