Individualization

Introduction

You can use the individualization function to fine tune the Voice Control System to your voice and therefore improve voice recognition. This means that other users' voices will not be recognized as easily. For this reason this function can be switched off.

Individualization comprises two parts and takes approximately 5 minutes. It consists of training the system to recognize a certain number of digit sequences and voice commands.

Starting new individualization

Individualization can only be started when the vehicle is stationary. Before starting, switch off all devices or functions which could interfere, such as the radio or the navigation system. After starting the session, the system guides you through the training with spoken instructions.

turning  the COMAND controller and Select Vehicle in the main function bar by turning press  to confirm. the COMAND controller and press to confirm.
the Select System by turning the the COMAND controller and press confirm. to confirm.
to Select Voice Control and press confirm. to confirm.
and press  to confirm. Select Start New Individualization and press to confirm.
You see and hear a prompt asking whether you would like further information.
confirm. Select Yes or No and press confirm. to confirm.
If you select No, the first part of individualization begins. You will be asked whether you would like to train digits or voice commands.
If you select Yes, you will see and hear information on the individualization process. The first part of individualization then begins automatically.
the To close the display: press the the COMAND controller.
You will be asked whether you would like to train digits or voice commands.

At the end of the first part, a prompt will

At the end of the first part, a prompt will appear asking whether you wish to begin the second part.

confirm. Select Yes or No and press confirm. to confirm.
If you select No, individualization will be canceled. The data from the first part is stored automatically.
If you select Yes, the second part will begin.

Individualization is completed at the end of the second part. You will see a message to this effect. The data from the second part is stored automatically.

Canceling the first or second part of

Canceling the first or second part of individualization

COMAND controller. Confirm Cancel by pressing COMAND controller. the COMAND controller.
A prompt appears asking whether you really wish to cancel.
confirm. Select Yes or No and press confirm. to confirm.
If you select Yes, individualization will be canceled. The data from the part during which you exited is not stored.
If you select No, the current part begins again.

Deleting existing individualization data

the Select Vehicle by turning COMAND controller and press  to the COMAND controller and press confirm. to confirm.
confirm. Select System and press confirm. to confirm.
to Select Voice Control and press confirm. to confirm.
press  to confirm. Select Delete Individualization and press to confirm.
A prompt appears asking whether you really wish to delete.
confirm. Select Yes or No and press confirm. to confirm.
If you select No, the process will be aborted.
If you select Yes, the individualization is deleted. You will see a message to this effect.

    See also:

    Opening/closing the garage door
    Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system. & ...

    Top Tether
    WARNING Always lock the rear seat backrests in their upright position when the rear seats are occupied by passengers. Lock the rear seat backrests in their upright position before installin ...

    Outside temperature display
    The outside temperature display is in the multifunction display. WARNING The outside temperature indicator is not designed to serve as an ice-warning device and is therefore unsuitable for t ...