Opening and closing the side windows

1 Front left

1 Front left
2 Front right
3 Rear right
4 Rear left

The switches for all side windows are located on the driver's door. There is also a switch on each door for the corresponding side window.

The switches on the driver's door take precedence.

from the rear when the override feature for The side windows cannot be operated from the rear when the override feature for the side windows is activated.

ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.
To open: press the corresponding switch.
If you press the switch beyond the point To close: pull the corresponding switch.

of resistance, an automatic opening/closing process is started in the If you press the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

windows after you switch off the engine or You can continue to operate the side windows after you switch off the engine or remove the SmartKey. This function is available for up to five minutes or until the driver's or front-passenger door is opened.

Sunblinds on the rear side windows

switch when the side window is closed. To close fully: pull the corresponding switch when the side window is closed.
switch. To open fully: press the corresponding switch.

doors to close the rear roller sunblinds for You can use the switches on the rear doors to close the rear roller sunblinds for the opposite side.

    See also:

    Range of the sensors
    General notes The sensors must be free of dirt, ice and slush; otherwise they may not function correctly. Clean the sensors regularly, taking care not to scratch or damage them (). Side view ...

    Important safety notes
    WARNING When opening or closing the door windows, make sure that there is no danger of anyone being harmed by the opening/closing procedure. The door windows are equipped with automatic ...

    Setting the front-compartment temperature using the front control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press the rocker switch up or down. Only change the temperature setting in small increments. Start at 72 °F (22 °C ...