Fuse box in the engine compartment
– Open the hood.
– Remove any existing moisture from the
fuse box using a dry cloth.
– To open: open clamps 2.
– Fold cover 1 upwards in the direction of
the arrow and remove it.
Make sure that no moisture can enter the fuse box when the cover is open.
– To close: check whether the seal is lying
correctly in cover 1.
– Insert cover 1 into the retainers at the side
of the fuse box.
– Fold down cover 1 and close clamps 2.
The cover must be positioned properly.
Moisture or dirt could otherwise impair the
operation of the fuses.
– Close the hood.
See also:
Selecting a folder
This function is only available in MP3 mode.
Switch on MP3 mode.
Select Search by sliding and
turning
the COMAND controller and press
to confirm.
Select Folder by sliding and
turning ...
Selecting a destination from the destination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My address". You may wish to
assign your home address to this entry, for
example, and select it for route
guidanc ...
Important safety notes
WARNING
The PARKTRONIC is a supplemental system.
It is not intended to, nor does it replace, the
need for extreme care. The responsibility
during parking and other critical maneuvers
...