Important safety notes
See the "Important safety notes" section.
If ESP® detects that the vehicle is deviating from the direction desired by the driver, one or more wheels are braked to stabilize the vehicle. If necessary, the engine output is also modified to keep the vehicle on the desired course within physical limits. ESP® assists the driver when pulling away on wet or slippery roads. ESP® can also stabilize the vehicle during braking.
If ESP® intervenes, the ESP® warning lamp flashes in the instrument cluster.
WARNING
Under no circumstances should you
deactivate ESP® when the
ESP®
warning lamp in the instrument cluster
flashes. Proceed as follows:
• when driving off, apply as little throttle as possible.
• while driving, ease up on the accelerator pedal.
• adapt your speed to suit the prevailing road and weather conditions.
Failure to observe these guidelines could
cause the vehicle to skid. ESP® cannot
prevent accidents resulting from excessive
speed.
Vehicles without 4MATIC: switch
the ignition off when:
• the parking brake is being tested using a dynamometer
• the vehicle is being towed with the front axle raised
Application of the brakes by ESP® may otherwise destroy the brake system.
Vehicles with 4MATIC: switch off the ignition when the parking brake is being tested on a brake dynamometer.
Application of the brakes by ESP® may otherwise destroy the brake system.
Vehicles with 4MATIC: function or performance tests may only be carried out on a 2-axle dynamometer. If you wish to operate the vehicle on such a dynamometer, please consult an authorized Mercedes-Benz Center in advance. You could otherwise damage the drive train or the brake system.
Only use wheels with the recommended tire sizes. Only then will ESP® function properly.
See also:
Important safety notes
Do not leave the SmartKey in the cargo compartment. You could otherwise lock
yourself out.
WARNING
When leaving the vehicle, always remove the SmartKey from the ignition lock.
Always take t ...
Problems with the seat heating
The seat heating has switched off
prematurely or cannot be switched on. The
vehicle's electrical system voltage is too low
because too many electrical consumers are
switched on.
- Switch off ...
Folding the rear seat backrest back
: Backrest
; Lock verification indicator
= Backrest release handle
Move the driver's or front-passenger seat forward if necessary.
Make sure that the seat belt does not become ...