Belt warning for the driver and front passenger
Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if the driver and the front passenger have fastened their seat belts.
If the driver's seat belt is not fastened after the engine is started, an additional warning tone will sound. The warning tone goes out after approximately six seconds or once the driver's seat belt is fastened.
If the driver or front passenger have not fastened their seat belt after 6 seconds and the doors are closed, the seat belt warning lamp lights up.
• until the driver or the front passenger have
fastened their seat belts
• if a vehicle speed of 15 mph (25 km/h) is
exceeded once, a warning tone with
increasing intensity sounds additionally for
a maximum of 60 seconds or until the driver
or front passenger have fastened their seat
belts.
If the driver or front passenger undo their seat belts during the journey, the seat belt warning lamp lights up and the warning tone sounds again.
The warning tone ceases even if the driver or front passenger have still not fastened their seat belt after 60 seconds. The seat belt warning lamp stops flashing but continues to be lit.
Once the vehicle is stationary, the warning tone is reactivated and the seat belt warning lamp starts to flash again if the vehicle speed exceeds 15 mph (25 km/h) once.
The seat belt warning lamp only
goes out if:
• both the driver and the front passenger have fastened their seat belts.
or
• the vehicle is stationary and a door is open.
For more information on the seat belt warning lamp, see "Warning and indicator lamps in the instrument cluster, seat belt"
See also:
Setting the B-pillar air vents
1 B-pillar air vent
2 Thumbwheel for B-pillar air vent
To open/close: turn thumbwheel 2 to the
left or right. ...
Starting procedure with the SmartKey
To start the engine using the SmartKey
instead of KEYLESS-GO, pull the Start/Stop button out of the ignition lock.
To start a gasoline engine: turn the
SmartKey to position 3 in the ignition lo ...
General notes
If you use the mechanical key to unlock and
open the driver's door or the trunk lid, the
anti-theft alarm system will be triggered.
There are several ways to turn off the alarm:
To turn the a ...