Windshield washer system andheadlamp cleaning system
The washer fluid reservoir is used for both the windshield washer system and the headlamp cleaning system.
Vehicle components and their service products must match. You should, therefore, only use products that have been tested and approved by Mercedes-Benz.
Information on tested and approved products can be obtained at any authorized Mercedes-Benz Center or on the Internet at http://www.mbusa.com (USA only).
WARNING
Washer solvent/antifreeze is highly
flammable. Do not spill washer solvent/antifreeze on hot engine parts, because
it may
ignite and burn. You could be seriously
burned.
At temperatures below freezing: always fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB WinterFit). There is otherwise a risk of damaging the windshield washer system/headlamp cleaning system.
Only use washer fluid concentrate which is suitable for plastic lenses. Unsuitable washer fluid concentrate could damage the plastic lenses of the headlamps.
Do not add distilled or de-ionized water to the washer fluid container. Otherwise, the level sensor may be damaged.
Add windshield washer concentrate, e.g.
MB SummerFit, to the washer fluid all year round.
Example: washer fluid reservoir
► Mix the windshield washer fluid in a
container beforehand.
► At temperatures above freezing: fill the
washer fluid reservoir with a mix of water and windshield washer concentrate
(e.g.
MB SummerFit).
► At temperatures below freezing: fill the
washer fluid reservoir with a mix of water
and windshield washer concentrate (e.g.
MB WinterFit). Adapt the mixing ratio to the outside temperature. For information on the mixing ratio.
► To open: pull cap 1 upwards by the tab.
► Add the premixed washer fluid.
► To close: press cap 1 onto the filler neck
until it engages.
See also:
Complete safety package for maximum occupant protection
In combination with the front and rear deformation zones, the Mercedes-Benz
GLK-Class's highstrength passenger cell provides a highly efficient foundation
for the occupant protection systems. Thes ...
COMAND display
Display overview
The COMAND display shows the function currently selected and its associated
menus. The
COMAND display is divided into several areas.
The radio display is shown in the example.
...
Adjusting the head restraint height electrically
To adjust the head restraint
height: slide
the switch for head restraint adjustment
up or down in the direction of
the arrow. ...