Rear seat head restraints
WARNING
For safety reasons, always drive with the rear
head restraints in the upright position when
the rear seats are occupied.
Keep the area around head restraints clear of
articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
WARNING
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint in such a way that it
is as close to the head as possible and the
center of the head restraint supports the back
of the head at eye level. This will reduce the
potential for injury to the head and neck in the
event of an accident or similar situation.
With a rear seat occupied, make sure to move
the respective head restraint up from the
lowest non-use position and have the
occupant adjust the head restraint properly.
Do not drive the vehicle without the seat head
restraints installed when the rear seats are
occupied. Head restraints are intended to
help reduce injuries during an accident.
See also:
Tire pressure of at least 180 kPa
(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved:
– Switch off the tire inflation compressor.
– Unscrew the filler hose from the valve of
the faulty tire.
– ...
Storing and maintaining the current speed
You can store the current speed if you are driving faster than 20 mph (30 km/h).
Accelerate the vehicle to the desired speed.
Briefly press the cruise control lever up 1 or down 2.
Remove your ...
Calibrating the compass
Make sure that there is sufficient space for you to drive in a circle
without impeding the remaining traffic.
In order to calibrate the compass correctly, observe the following points:
ca ...