Switching the windshield wipers on/ off
WARNING
Wiper blades are components that are subject to wear and tear. Replace the wiper blades twice a year, preferably in the spring and fall. Otherwise the windows will not be wiped properly. As a result, you may not be able to observe surrounding traffic conditions and could cause an accident.
Do not operate the windshield wipers when the windshield is dry, as this could damage the wiper blades. Moreover, dust that has collected on the windshield can scratch the glass if wiping takes place when the windshield is dry.
If the windshield wipers leave smears on the windshield after the vehicle has been washed in an automatic car wash, wax or other residues may be the reason for this. Clean the windshield using washer fluid after washing the vehicle in an automatic car wash.
Combination switch
1 Windshield wipers off
2 Intermittent wipe, low
3 Intermittent wipe, high
4 Continuous wipe, slow
5 Continuous wipe, fast
6 Single wipe/
To wipe the windshield using washer
fluid
- Switch on the ignition.
- Turn the combination switch to the corresponding position.
Vehicles with a rain sensor: if the windshield becomes dirty in dry weather conditions, the windshield wipers may be activated inadvertently. This could then damage the windshield wiper blades or scratch the windshield.
For this reason, you should always switch off the windshield wipers in dry weather.
Vehicles with a rain sensor: in the Ä or Å position, the appropriate wiping frequency is automatically set according to the intensity of the rain. In the Å position, the rain sensor is more sensitive than in the Ä position, causing the windshield wipers to wipe more frequently.
See also:
Selecting the screen for the remote control
Turn thumbwheel 3 until the desired
display is highlighted in the window. ...
Important safety notes
WARNING
On slippery road surfaces, never downshift in
order to obtain braking action. This could
result in drive wheel slip and reduced vehicle
control. Your vehicle's ABS will not prevent
...
Deactivating the HOLD function
The HOLD function is deactivated automatically if:
• you accelerate and the transmission is in position D or R.
• you shift the transmission to position P.
• you apply the brakes again with a certa ...