Storing settings
With the memory function, you can store up to three different settings, e.g. for three different people.
The following settings are stored as a single memory preset:
- position of the seat, backrest and head
restraint
- active multicontour seat: dynamic function
level
- driver's side: steering wheel position
- driver's side: position of the exterior
mirrors on the driver's and front-passenger
sides
WARNING
Do not activate the memory function while
driving. Activating the memory function while
driving could cause the driver to lose control
of the vehicle.
•► Adjust the seat
•► On the driver's side, adjust the steering wheel and the exterior mirro
•► Press memory button M and one of the storage position buttons 1, 2 or 3 within three seconds.
The settings are stored in the selected preset position. A tone sounds when the settings have been completed.
See also:
Points to observe before use
The socket in the center console and the
socket in the cargo compartment are not
intended for operating the tire inflation
compressor.
The sockets can be used for accessories, e.
g. lamps o ...
Important information
The cooling with air dehumidification function is only available when the engine
is running. The air inside the vehicle is cooled and dehumidified according to the
temperature selected.
WARN ...
Switching to video AUX mode
Select Video in the main function bar by
sliding and turning
the COMAND
controller and press to confirm.
If video AUX mode was the last mode
selected, it will now be active.
If another vi ...