Genuine Mercedes-Benz parts

All Mercedes-Benz Centers maintain a supply of genuine Mercedes-Benz parts for necessary service and repair work. In addition, strategically located parts delivery centers provide for quick and reliable parts service.

There are more than 300,000 different genuine Mercedes-Benz parts available for Mercedes-Benz models.

Genuine Mercedes-Benz parts are subject to strict quality control. Each part has been specially developed, manufactured or selected for Mercedes-Benz vehicles and fine-tuned for them.

Therefore, only genuine Mercedes-Benz parts should be used.

WARNING
Driving safety may be impaired if nonapproved parts, tires and wheels or safetyrelevant accessories are used.
This could lead to malfunctions in safetyrelevant systems, e.g. the brake system. This could cause you to lose control of your vehicle and cause an accident.
For this reason, Mercedes-Benz recommends that you use genuine Mercedes-Benz parts or parts of equal quality. Only use tires, wheels and accessories that have been specifically approved for your vehicle.

Tensioning Air bags and Emergency Tensioning Devices, as well as control units and sensors for these restraint systems may be installed in the following areas of your vehicle:
• doors
• door pillars
• door sills
• seats
• dashboard
• instrument cluster
• center console
Do not install accessories such as audio systems in these areas. Do not carry out repairs or welding. You could impair the operating efficiency of the restraint systems.
Have aftermarket accessories installed at a qualified specialist workshop. Mercedes- Benz recommends that you use an authorized Mercedes-Benz Center for this purpose.

Environmental note
Daimler AG also supplies reconditioned major assemblies and parts which are of the same quality as new parts. They are covered by the same Limited Warranty entitlements as new parts.

Always specify the vehicle identification number (VIN) and the engine number when ordering genuine Mercedes-Benz parts

    See also:

    Setting the temperature in the rear compartment using the rear control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press rocker switch 12 or 17 up or down. Only change the temperature setting in small increments. Start at 72 °F (22 ...

    Adding engine oil
    WARNING If engine oil comes into contact with hot engine parts, it may ignite and you could burn yourself. Do not spill any engine oil on hot engine parts. Environmental note When adding ...

    Fuel requirements
    Use only premium-grade unleaded gasoline. The octane number should be at least 91. Details can be found on the gas pump. The octane number is the average value of the Research Octane Number (RON) ...