Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
Turn the SmartKey to position 2
in the
ignition lock.
Press transmitter button 2, 3 or 4
in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code: indicator lamp 1 lights up green.
Garage door system with a rolling code: indicator lamp 1 flashes green.
The transmitter will transmit a
signal for
as long as the transmitter button is being
pressed. After a maximum of ten seconds,
transmission is terminated and indicator
lamp 1 flashes yellow. Press the
transmitter button again, if necessary.
See also:
Service and literature
Your vehicle is covered under the terms of the
warranties printed in the Service and
Warranty Information booklet. Your
authorized Mercedes-Benz Center will
exchange or repair any defective pa ...
Important safety notes
Service products include the following:
fuels (e.g. gasoline, diesel)
lubricants (e.g. engine oil, transmission oil)
coolant
brake fluid
windshield washer fluid
Vehicle components and t ...
Tire pressure of 180 kPa (1.8 bar/
26 psi) is reached
– Switch off the tire inflation compressor.
– Unscrew the filler hose from the valve of
the faulty tire.
After use, excess TIREFIT may run out of
the filler hose. This could cause stains.
...