Activating the HOLD function

conditions Make sure that the activation conditions are met.
Depress the brake pedal.

Quickly depress the brake pedal

further Quickly depress the brake pedal further until HOLD display 1 appears in the multifunction display.
The HOLD function is activated. You can release the brake pedal.

the first If depressing the brake pedal the first time does not activate the HOLD function, wait briefly and then try again.

WARNING
The vehicle's brakes are applied when the HOLD function is activated. For this reason, deactivate the HOLD function if the vehicle is to be set in motion by other means (e.g. in a car wash or by towing).

    See also:

    Speed rating
    The speed rating is part of the tire identification. It specifies the speed range for which the tire is approved. ...

    Engine number
    1 Emission control information plate, including the certification of both federal and Californian emissions standards 2 Engine number (stamped into the crankcase) 3 VIN (on the lower edg ...

    Brilliant finish: the rear assembly of the M-Class
    The rear area too of the M-Class also protects the sturdy passenger compartment in crash situations thanks to specific deformation work, therefore minimising the loads on the occupants. A special ...