Storing the current speed or calling up the last stored speed

WARNING
The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from returning to the preset speed could cause an accident and/or serious injury to you and others.

lever towards you 4. Briefly pull the cruise control lever towards you 4.
accelerator pedal. Remove your foot from the accelerator pedal.
The first time cruise control is activated, it stores the current speed or regulates the speed of the vehicle to the previously stored speed.

    See also:

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where ...

    Introduction
    You can establish a Bluetooth® connection to COMAND (see the separate operating instructions). WARNING   A driver's attention to the road must always be his/her primary focus when drivi ...

    Operating the panorama roof with power tilt/sliding panel
    Opening and closing Overhead control panel 1 To raise 2 To open 3 To close/lower The panorama roof with power tilt/sliding panel can only be operated when the roller sunblind is open. Tur ...