Using KEYLESS-GO

The KEYLESS-GO key must be outside the vehicle. All the doors must be closed.

Touch recessed sensor surface 1

on the Touch recessed sensor surface 1 on the door handle until the side windows and the sliding sunroof or the panorama roof with power tilt/sliding panel are fully closed.

recessed Make sure you only touch recessed sensor surface 1.

windows and the Make sure that all the side windows and the sliding sunroof or panorama roof with power tilt/sliding panel are closed.

On vehicles with a panorama roof with power tilt/sliding panel:
the door handle again until the roller sunblinds of the panorama roof with power Touch recessed sensor surface 1 on the door handle again until the roller sunblinds of the panorama roof with power tilt/sliding panel close.
closing: release recessed sensor surface 1 on the door handle. To interrupt convenience closing: release recessed sensor surface 1 on the door handle.

    See also:

    Power washers
    WARNING Do not use power washers with circular-jet nozzles (dirt grinders) to clean your vehicle, in particular the tires. You could otherwise damage the tires and cause an accident. Always ...

    Switching traffic reports on/off
    To switch on: set the route type to Dynamic Route. To switch off: select the Fast Route or Short Route route type. COMAND calculates a new route if you change the route type setting with ro ...

    Changing gear
    The automatic transmission shifts to the individual gears automatically when it is in transmission position D. This automatic gearshifting behavior is determined by: a shift range restriction, ...