Fuse box in the engine compartment
- Make sure that the windshield wipers are turned off.
WARNING
Make sure that the windshield wipers are switched off and that the SmartKey is removed from the ignition lock before you open the cover of the fuse box. Otherwise, the windshield wipers and the wiper rods above the cover could be set in motion. This could lead to you or others being injured by the wiper rods.
- Open the hood ().
- Remove any existing moisture from the fuse box using a dry cloth.
- Take lines 2 from the guides.
- To open: open clamps 1.
- Remove the fuse box cover forwards.
Make sure that no moisture can enter the fuse box when the cover is open.
- To close: check whether the rubber seal is lying correctly in the cover.
- Insert the cover at the rear of the fuse box into the retainer.
- Fold down the cover and close clamps 1.
- Secure lines 2 in the guides.
The cover must be seated properly, otherwise moisture or dirt could impair
the function of the fuses.
- Close the hood ().
See also:
Using the rear center seat belt
If the left-hand rear seat backrest is folded down and back up again, the rear
center seat belt may lock. The seat belt can then not be pulled out.
To release the rear center seat belt: pull out ...
Connection options
Overview
You will find the connection sockets in the
glove box.
Device-specific adapter cables are required
to connect external devices to the Media
Interface. These cables are included in the ...
INTERIOR
It's inside the R-Class where some of those previously mentioned quirks start
rearing their ugly heads.
The R-Class has an electronic gearshift lever on the steering wheel. Putting
the car into ...