Opening/closing the garage door

Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

X Turn the SmartKey to position 2 in the ignition lock.

X Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp 1 lights up continuously.

Garage door system with rolling code: indicator lamp 1 flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds.

is being pressed. The transmission will be halted after a maximum of 20 seconds The transmitter will transmit a signal for as long as the transmitter button is being pressed. The transmission will be halted after a maximum of 20 seconds and indicator lamp 1 will flash. Press the transmitter button again, if necessary.

    See also:

    Notes on USB devices
    Data formats The following data formats are supported: • MP3: CBR, VBR (up to 320 kbit/s) • WMA: CBR, VBR (up to 320 kbit/s) Notes on USB devices • In order to keep the initialization time to ...

    Problems with the seat ventilation
    The seat ventilation has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. •► ...

    Adjusting the head restraint height electrically
    To adjust the head restraint height: slide the switch for head restraint adjustment up or down in the direction of the arrow. ...