Transfer case
This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is always transmitted to both axles.
Performance tests may only be carried out on a 2-axle dynamometer. The brake system or transfer case could otherwise be damaged. Contact a qualified specialist workshop for a performance test. Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose.
To prevent ESP® from intervening, the ignition must be switched off (SmartKey in position 0 or 1) if:
- the parking brake is being tested on a brake dynamometer.
- the vehicle is being towed with only one axle raised (not permitted for vehicles with 4MATIC).
The brake system could otherwise be damaged.
See also:
Switching maximum cooling MAX
COOL on/off
The MAX COOL function is only available in
vehicles for the USA.
MAX COOL is only operational when the
engine is running.
When you activate MAX COOL, climate
control switches to the following ...
Storing and maintaining the current speed
You can store the current speed if you are driving faster than 20 mph (30 km/h).
Accelerate the vehicle to the desired speed.
Briefly press the cruise control lever up 1 or down 2.
Remove your ...
Entering a point of interest in the
vicinity of the destination
Entering a point of interest in the vicinity of
the destination is only possible when route
guidance is active.
Select Destination Area from the menu
and press to confirm.
Continue with ass ...