Transmission position and drive program display

  1. Transmission position display
  2. Drive program display

The current position of the selector lever is shown by the indicators next to the selector lever.

The indicators light up when the SmartKey is inserted into the ignition lock. The indicators go out when the SmartKey is removed from the ignition lock.

    See also:

    Change of direction
    Introduction Changes of direction have three phases: • preparation phase • announcement phase • change-of-direction phase Preparation phase COMAND prepares you for the upcoming change of ...

    Cup holder in the front-compartment center console
    You can remove the cup holder to clean it. Clean with clear, lukewarm water only. To open: press marking 1. To remove: slide catch 2 back and pull the cup holder upwards. To insert: insert ...

    Cargo tie-down rings
    Observe the following notes on securing loads: secure the load using the cargo tie down rings. do not use elastic straps or nets to secure a load, as these are only intended as an anti-slip p ...