Tail lamp
- Switch off the lights.
- Open the cargo compartment.
- Open the side trim panel ().
- Pull out connector 2.
- Press retaining lugs 1 simultaneously in the direction of the arrow and pull the bulb holder out.
Bulb holder without LED turn signal lamp
- Tail lamp/brake lamp
- Turn signals
- Backup lamp
- ear fog lamp/tail lamp
- Side marker lamp
- Lightly press the corresponding bulb into the holder, turn it counter-clockwise and remove it from the bulb holder.
- Insert the corresponding new bulb into the bulb holder and turn it clockwise.
- Attach the bulb holder and press firmly. The retaining lugs on the bulb holder engage audibly.
- Insert the connector.
- Close the side trim panel ().
See also:
Engine number
1 Emission control information plate,
including the certification of both federal
and Californian emissions standards
2 Engine number (stamped into the
crankcase)
3 VIN (on the lower edge of ...
General notes
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device must ...
Service and literature
Your vehicle is covered under the terms of the
warranties printed in the Service and
Warranty Information booklet. Your
authorized Mercedes-Benz Center will
exchange or repair any defective pa ...