High-beam headlamps (halogen headlamps)
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn housing cover 1 counter-clockwise and pull it out.
- Press the handle of bulb holder 2 in the direction of the arrow until bulb holder 2 is released.
- Take out the handle with bulb holder 2.
- Take the bulb out of bulb holder 2.
- Insert the new bulb into bulb holder 2. Lug 3 of the bulb must be pointing upward.
- Insert bulb holder 2.
- Push the handle of bulb holder 2 in the opposite direction from the arrow until holder 2 engages.
- Align housing cover 1 and turn it clockwise until it engages.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
See also:
Windshield washer system and
headlamp cleaning system
The washer fluid reservoir is used for both the
windshield washer system and the headlamp
cleaning system.
Vehicle components and their service
products must match. You should,
therefore, onl ...
Coolant temperature display
WARNING
Driving when your engine is overheated can
cause some fluids which may have leaked into
the engine compartment to catch fire. You
could be seriously burned.
Steam from an overheated ...
Cargo tie-down rings
Observe the following notes on securing
loads:
- secure the load using the cargo tie down
rings.
- do not use elastic straps or nets to secure
a load, as these are only intended as an
anti-s ...