SmartKey
| Display messages | Possible causes/consequences and
Solutions |
![]() |
You have put the wrong SmartKey in the ignition lock. Use the correct SmartKey. |
![]() |
The SmartKey is in the ignition lock. Remove the SmartKey. |
![]() |
The SmartKey needs to be replaced. Visit a qualified specialist workshop. |
![]() |
The batteries of the KEYLESS-GO key are discharged. Change the batteries. |
![]() |
The display message is shown for a maximum of 60 seconds and is only
a reminder. You have opened the driver's door with the engine switched off. The KEYLESS-GO key is not in the ignition lock. Remember to take the KEYLESS-GO key with you when you leave the
vehicle. |
![]() |
The KEYLESS-GO key is not in the vehicle. A warning tone also sounds. If the engine is switched off, you can no longer lock the vehicle centrally or start the engine. Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions. Engage the electric parking brake. Locate the KEYLESS-GO key. |
| The KEYLESS-GO key is not detected while the engine is running
because there is interference from a strong source of radio waves. A warning tone also sounds. Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions. Engage the electric parking brake. Operate the vehicle with the SmartKey in the ignition lock. |
|
![]() |
The KEYLESS-GO key cannot be detected at present. Change the location of the key with the KEYLESS-GO functions in the
vehicle.If the KEYLESS-GO key is still not detected: Operate the vehicle with the SmartKey in the ignition lock. |
![]() |
The KEYLESS-GO key has been detected inside the vehicle during
locking. Remove the KEYLESS-GO key from the vehicle. |
![]() |
KEYLESS-GO is temporarily malfunctioning or is defective. Insert the SmartKey into the ignition lock and turn it to the desired
position. Visit a qualified specialist workshop. |
![]() |
At least one door is open. A warning tone also sounds. Close all doors and lock the vehicle again. |
See also:
Trip computer "From start" or "Fromreset"
The values in the From Start submenu refer
to the start of your journey, while those in the
From Reset submenu refer to the last time
you reset this submenu.
► Press the
button on the
s ...
Route mode
Setting route type and route options
You can select the following route types:
• Fast Route: COMAND calculates the
route with the shortest (minimized) journey
time.
• Dynamic Route: same ro ...
Setting the center air vents
Setting the center air vents
1 Center air vent, left
2 Center air vent, right
3 Center vent thumbwheel, right
4 Center vent thumbwheel, left
To open/close: turn
thumbwheels 3 and 4 up or dow ...

Solutions








