Vehicle level
Your vehicle automatically adjusts its ride height to improve driving safety and reduce fuel consumption.
Depending on the vehicle height that has been set, the vehicle automatically adjusts its height dependent on the current speed. As speed increases, the vehicle is lowered by up to 0.6 in (15 mm). As the speed is reduced, the vehicle is raised up to the set vehicle height.
WARNING
The vehicle is lowered when the engine is
switched off. Therefore, make sure that
nobody is in the vicinity of the wheel housing
or under the vehicle when you switch off the
engine. Otherwise, limbs could become
trapped.
The vehicle is lowered when the engine is switched off. Make sure when parking that you position your vehicle so that it does not make contact with the curb as the vehicle is lowered. Your vehicle could otherwise be damaged.
For AMG vehicles: when the engine is switched off, the vehicle is lowered by approx. 0.4 in (10 mm).
Setting the vehicle level
Select the "Normal" setting for normal road surfaces and "Raised" for driving with snow chains or on particularly poor road surfaces.
WARNING
To help avoid personal injury, keep hands and
feet away from wheel housing area, and stay
away from under the vehicle when lowering
the vehicle chassis.
Your selection remains stored even if you remove the SmartKey from the ignition lock.
Setting raised level
Start the engine.
If indicator lamp 2 is not lit:
Press button 1.
Indicator lamp 2 lights up. The vehicle height is adjusted to raised level.
Setting the normal level
Start the engine.
If indicator lamp 2 is lit:
Press button 1.
Indicator lamp 2 goes out. The vehicle is adjusted to normal level.
See also:
GL350 Bluetec in the Market
The GL350 Bluetec rides and handles as well as anything in the full-size
luxury SUV segment, and its interior is appropriately luxurious. Despite its
problems, it's also a strong seller in its cla ...
Adjusting the multicontour seat
You can adjust the contour of the front seats
individually so as to provide optimum support
for your back and sides.
► Make sure that the SmartKey is in
position
2 in the ignition lock.
...
General notes
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device must ...