Activation conditions

You can activate the HOLD function if:
• the vehicle is stationary.
• the driver's door is closed or your seat belt is fastened.
• the electric parking brake is released.
• the hood is closed.
• the transmission is in position R, N or D.
The trunk lid must be closed in position R.
• DISTRONIC PLUS is deactivated.

    See also:

    Drive sensibly – save fuel
    Observe the following tips to save fuel: The tires should always be inflated to the recommended tire pressure. Remove unnecessary loads. Remove roof racks when they are not needed. Warm up ...

    Vehicle tool kit
    The vehicle tool kit can be found in the stowage well under the trunk floor/cargo compartment floor. Depending on the vehicle equipment, the vehicle tool kit is on the lefthand side or the rig ...

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt:pull o ...