Sets the specified minimum distance

You can set the specified minimum distance for DISTRONIC PLUS by varying the time span between one and two seconds. With this function, you can set the minimum distance that DISTRONIC PLUS keeps to the vehicle in front, dependent on vehicle speed. You can see this distance in the multifunction display.

WARNING
It is up to the driver to exercise discretion to select the appropriate setting given road conditions, traffic, driver's preferred driving style and applicable laws and driving recommendations for safe following distance.

To increase: turn control 2 in direction

3. To increase: turn control 2 in direction 3.

DISTRONIC PLUS then maintains a greater distance between your vehicle and the vehicle in front.

direction 1. To decrease: turn control 2 in direction 1.

DISTRONIC PLUS then maintains a shorter distance between your vehicle and the vehicle in front.

and safe distance from the vehicle in front. Make sure that you maintain a sufficient and safe distance from the vehicle in front.
Adjust the distance to the vehicle in front if necessary.

    See also:

    Setting the temperature in the rear compartment using the rear control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press rocker switch 12 or 17 up or down. Only change the temperature setting in small increments. Start at 72 °F (22 ...

    Adjusting the rear seat head restraint angle
    Adjust the head restraints so that they are as close as possible to your head. You can only adjust the two outer head restraints. X Pull or push the top of the head restraint until it is in the de ...

    Restoring the factory settings
    ► Press the buttons simultaneously for approximately six seconds until the battery check lamp flashes twice. ...