Storing the current speed or calling up a stored speed

WARNING
The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from returning to the preset speed could cause an accident and/or serious injury to you and others.

you 4. Briefly pull the cruise control lever towards you 4.

pedal. Remove your foot from the accelerator pedal.

DISTRONIC PLUS is activated. The first time it is activated, the current speed is stored. Otherwise, it sets the vehicle cruise speed to the previously stored value.

    See also:

    Towing the vehicle with the rear axle raised
    Only possible on vehicles without 4MATIC. When towing your vehicle with the rear axle raised, it is important that you observe the safety instructions. The ignition must be switched off if yo ...

    Call priority
    When service calls are active, e.g. Roadside Assistance or MB Info calls, an emergency call can still be initiated. In this case, an emergency call will take priority and override all other ac ...

    Operating the panorama roof with power tilt/sliding panel
    Opening and closing Overhead control panel 1 To raise 2 To open 3 To close/lower The panorama roof with power tilt/sliding panel can only be operated when the roller sunblind is open. Tur ...