Deactivating/activating the ECO start/stop function

General information

You can deactivate and activate the ECO start/stop function using COMAND.

button to activate and You can also use the programmable button to activate and deactivate the ECO start/stop function if you have assigned this function to the button.

Deactivating

using COMAND: Deactivate the ECO start/stop function using COMAND:

The Stop/Start deactivated display ECO symbol goes out and the Stop/Start deactivated display message is shown in the multifunction display.

the ECO start/stop function is always If drive program S or M has been selected, the ECO start/stop function is always deactivated.

Activating

COMAND. Activate the ECO start/stop function using COMAND.

The Start active display message are shown ECO symbol and the Stop/ Start active display message are shown in the multifunction display.

If not all conditions for automatic engine switch-off are fulfilled, the Stop/Start inactive message appears.

function in drive program S or M, drive If you activate the ECO start/stop function in drive program S or M, drive program C is selected automatically.

    See also:

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where ...

    Blind Spot Assist
    Important safety notes Blind Spot Assist uses a radar sensor system to monitor the areas on both sides of your vehicle. It supports you from speeds of approximately 20 mph (30 km/h). A warning ...

    Assigning the programmable button (favorites)
    1 Programmable button You can assign the following predefined functions to the programmable button: • ECO: you can activate or deactivate the ECO start/stop function. • Massage, Driver's ...