Selecting an active partition (USB mass storage devices only)
You can select this function for USB mass storage devices when the storage device is partitioned. Up to four partitions (primary or logical; FAT format) are supported.
The Windows formatting program
supports FAT partitioning up to 32 GB as
standard.
Select Media Interface in the basic
display by sliding
and turning
the
COMAND controller and press
to
confirm.
Select Select Active Partition and
press
to confirm.
See also:
Drive sensibly – save fuel
Observe the following tips to save fuel:
The tires should always be inflated to the recommended tire pressure.
Remove unnecessary loads.
Remove roof racks when they are not needed.
Warm ...
Opening the hood
WARNING
Do not pull the release lever while the vehicle
is in motion. Otherwise, the hood could be
forced open by passing air flow.
This could cause the hood to come loose and
injure you and ...
Overview
Outrageous proportions: a long bonnet, narrow-look windows with frameless
side windows, dynamic roof sweeping back at an angle towards the rear. In 2003
the four-door Coupé was born: and th ...
