Requirements for a Bluetooth® connection

You can connect mobile phones and notebooks to COMAND.

To do so, the following conditions need to be met:
• Bluetooth®-capable devices, e.g. mobile phones, must comply with a certain profile in order to be connected to COMAND.
Every Bluetooth® device has its own specific Bluetooth® name.
• Bluetooth® must be activated in COMAND and on the respective Bluetooth® device; see the separate operating instructions.
• the Bluetooth® device must be "visible" to COMAND in order for COMAND to find and display it. For the setting procedures, please see the operating instructions for the Bluetooth® device.

connected, reception and transmission Once a mobile phone has been connected, reception and transmission volume may change.

    See also:

    Storing the current speed or calling up the last stored speed
    WARNING The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from ...

    CD/DVD drive and AUX jacks
    The CD/DVD drive is located in the center behind the front seats. 1 CD/DVD slot 2 AUX, right-hand (R) jack for audio signal 3 AUX, left-hand (L) jack for audio signal 4 AUX, jack for vid ...

    Making adjustments in 5 mph (Canada: 10 km/h) increments
    •► Briefly press the cruise control lever beyond the pressure point, up 1 for a higher speed or down 2 for a lower speed. The last speed stored is increased or reduced. ...