Selecting a menu item
The following example describes how to select a station from the station presets in radio mode.
Press the 
function button.
Select Presets by sliding 
and
turning
the COMAND controller and press
to confirm.
The station preset memory appears.
1 Selection bar
Select a station by turning
the
COMAND controller and press to
confirm.
The station is set.
See also:
Trip computer "From start" or "From reset"
The values in the From Start submenu are
calculated from the start of a journey, while
the values in the From Reset submenu are
calculated from the last time the submenu
was reset.
Press the ...
Stowage well under the trunk floor
The TIREFIT kit, the vehicle tool kit, etc. are
located in the stowage compartment.
To open: pull handle 1
upwards.
Hook handle 1 into rain trough
2.
Unhook the handle before again
b ...
Adaptive Highbeam Assist
You can use this function to set the
headlamps to change between low beam and
high beam automatically. The system
recognizes vehicles with their lights on, either
approaching from the opposite ...