Cleaning instructions

display has a very sensitive high-gloss Do not touch the COMAND display. The display has a very sensitive high-gloss surface; there is a risk of scratching. If you have to clean the screen, however, use a mild cleaning agent and a soft, lint-free cloth.

The display must be switched off and have cooled down before you start cleaning. Clean the display screen, when necessary, with a commercially available microfiber cloth and cleaning agent for TFT/LCD displays. Then, dry the surface with a dry microfiber cloth.

Avoid using alcoholic thinners, gasoline or abrasive cleaning agents. These could damage the display surface. Do not apply pressure to the display surface when cleaning it, as this could cause irreversible damage.

    See also:

    Setting the center air vents
    1 Center air vent, left 2 Center air vent, right 3 Center vent thumbwheel, right 4 Center vent thumbwheel, left - To open/close: turn thumbwheels 3 and 4 to the right or left. ...

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the bod ...

    Automatic transmission
    Shift the transmission to position P. The transmission position display in the multifunction display shows P. You can also start the engine when the transmission is in position N. ...