Seat belt adjustment

The seat-belt adjustment function adjusts the driver's and front-passenger seat belt to the upper body of the occupants.

The belt strap is tightened slightly when:

• you engage the belt tongue in the belt buckle and you then turn the SmartKey to position 2 in the ignition lock.

• the SmartKey is in position 2 in the ignition lock and you then engage the belt tongue in the buckle.

The seat-belt adjustment will apply a retraction force if any slack is detected between the occupant and the seat belt. Do not hold on to the seat belt tightly while it is adjusting. You can switch the seat-belt adjustment on and off in the on-board computer.

The seat-belt adjustment is an integral part of the PRE-SAFE® convenience function. More information about PRE-SAFE® can be found in the "PRE-SAFE® (preventative occupant protection)" section.

    See also:

    Removing the mechanical key
    Push release catch 1 in the direction of the arrow and at the same time, remove mechanical key 2 from the SmartKey. ...

    Smaller tank, same range
    Because the new Mercedes CLS models consume significantly less fuel, it has been possible to reduce the filling volume of the fuel tank in the four and six-cylinder models to 59 litres. The 80-lit ...

    Tire characteristics
    Tire data is vehicle-specific and may deviate from the data in the example. This information describes the tire cord and the number of layers in sidewall 1 and under the tread 2. ...