Fuse box in the engine compartment

•► Make sure that the windshield wipers are turned off.

WARNING
Make sure that the windshield wipers are switched off and that the SmartKey is removed from the ignition lock before you open the cover of the fuse box. Otherwise, the windshield wipers and the wiper rods above the cover could be set in motion. This could lead to you or others being injured by the wiper rods.

•► Open the hood

•► Remove any existing moisture from the

•► Remove any existing moisture from the fuse box using a dry cloth.

•► Take lines 2 from the guides.

•► Move aside lines 2. Route the lines behind connection 3 to do this.

•► To open: open clamps 1.

•► Remove the fuse box cover forwards.

Make sure that no moisture can enter the fuse box when the cover is open.

•► To close: check whether the rubber seal is lying correctly in the cover.

•► Insert the cover at the rear of the fuse box into the retainer.

•► Fold down the cover and close clamps 1.

•► Secure lines 2 in the guides.

The cover must be seated properly, otherwise moisture or dirt could impair the function of the fuses.

•► Close the hood

    See also:

    Important safety notes
    WARNING On slippery road surfaces, never downshift in order to obtain braking action. This could result in drive wheel slip and reduced vehicle control. Your vehicle's ABS will not prevent ...

    Bag hooks
    The bag hook can bear a maximum load of 11 lbs (5 kg). Do not use it to secure a load. There is one bag hook on the left side wall in the cargo compartment and there are two hooks on the right ...

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt: pull out ...