Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

•► Turn the SmartKey to position 2 in the ignition lock.

•► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Using KEYLESS-GO
    The KEYLESS-GO key must be outside the vehicle. All the doors must be closed. •► Touch recessed sensor surface 1 on the door handle until the side windows and the sliding sunroof or the ...

    Center console, upper section
    1 Audio system/COMAND; see the separate operating instructions 2 Seat heating 3 Seat ventilation 4 PARKTRONIC 5 Downhill Speed Regulation (vehicles without AIRMATIC package) 6 Hazard war ...

    Important safety notes
    WARNING Make sure the trunk lid is closed when the engine is running and while driving. Among other dangers, deadly carbon monoxide (CO) gases may enter the vehicle interior resulting in un ...