Fogged up or dirty windshield
If the windshield in front of the camera is fogged up or dirty on the inside or outside, the Night View Assist Plus display is affected.
WARNING
Please do not forget that your primary
responsibility is to drive the vehicle. A driver's
attention to the road must always be his/her
primary focus when driving. For your safety
and the safety of others, stop before trying to
remove window fogging or cleaning the
windshield in front of the Night View Assist
Plus camera.
Bear in mind that at a speed of just 30 mph (approximately 50 km/h), your vehicle is covering a distance of 44 feet (approximately 14 m) every second.
•► To defrost: check the automatic air conditioning settings and fold down the camera cover.
•► To defrost the inside of the windshield: fold down the camera cover and clean the windshield
See also:
Correct use of the seat belts
WARNING
USE SEAT BELTS PROPERLY
• Seat belts can only work when used
properly. Never wear seat belts in any other
way than as described in this section, as
that could result in seriou ...
Switching on/off
The three red indicator lamps in the button
indicate the heating level you have selected.
If the battery voltage is too low, the seat
heating may switch off.
Driver's and front-passenger seat
...
Engine number
Emission control information plate, including the certification of both
federal and Californian emissions standards
Engine number (stamped into the crankcase)
VIN (on the lower edge of the ...