Activating the HOLD function

•► Make sure that the activation conditions are met.

•► Depress the brake pedal.

•► Quickly depress the brake pedal further

•► Quickly depress the brake pedal further until HOLD display 1 appears in the multifunction display.

The HOLD function is activated. You can release the brake pedal.

If depressing the brake pedal the first time does not activate the HOLD function, wait briefly and then try again.

WARNING
The vehicle's brakes are applied when the HOLD function is activated. For this reason, deactivate the HOLD function if the vehicle is to be set in motion by other means (e.g. in a car wash or by towing).

    See also:

    Ruts and gravel roads
    Observe the following rules when driving along ruts in off-road terrain or on roads with loose gravel: Check that the ruts are not too deep and that your vehicle has sufficient clearance. O ...

    Smaller tank, same range
    Because the new Mercedes CLS models consume significantly less fuel, it has been possible to reduce the filling volume of the fuel tank in the four and six-cylinder models to 59 litres. The 80-lit ...

    Checking tire pressures manually
    To determine and set the correct tire pressure, proceed as follows: – Remove the valve cap of the tire that is to be checked. – Press the tire pressure gauge securely onto the valve. – Read t ...