General information
The ECO start/stop function is only available for the E 63 AMG.
The ECO start/stop function is only available in drive program C.
The ECO start/stop function switches the engine off automatically when the vehicle stops moving.
The engine starts automatically when the driver wants to pull away again. The ECO start/stop function thereby helps you to reduce the fuel consumption and emissions of your vehicle.
The ECO start/stop function is activated each
time the engine is switched on. If all the
requirements are fulfilled for automatic
engine switch-off (Y page 149), the green
ECO symbol is shown in the
multifunction display and Stop/Start
active appears. If not all of the requirements
are fulfilled, the
ECO symbol is
shown
in yellow and Stop/Start inactive
appears.
If the ECO start/stop function is deactivated, the
symbol is not shown.
WARNING
If the engine is switched off and the ECO
symbol is shown in green in the multifunction
display, the engine has been switched off
automatically. All of the vehicle's systems
remain active. If you open the door, unfasten
your seat belt or remove your foot from the
brake pedal, the engine will automatically
start. The vehicle may begin moving. You
could suffer serious or even fatal injury or
cause an accident resulting in injury or death.
Never leave the vehicle while the ECO symbol in the multifunction display is shown in green or yellow. Always secure the vehicle against rolling away before leaving it.
Always switch the ignition off and take the key with you when leaving the vehicle.
See also:
Useful information
This Operator's Manual describes all models and all standard and optional equipment
of your vehicle available at the time of publication of the Operator's Manual. Country-specific
diffe ...
Mounting a new wheel
WARNING
Always replace wheel bolts that are damaged
or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be
repaired immediately. Do not continue to
drive ...
Selecting a station
Selecting a station using the station
search function
Turn or slide
the COMAND
controller while the display/selection
window in the radio display is active.
Station search scans up or down ...