Releasing seat belts
- Press release button 4 and guide belt tongue ; back towards belt sash guide 1.
Make sure that the seat belt is fully rolled up. Otherwise, the seat belt or belt tongue will be trapped in the door or in the seat mechanism. This could damage the door, the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
See also:
Charging the battery
WARNING
Never charge a battery still installed in the
vehicle unless a battery charger unit approved
by Mercedes-Benz is being used. Gases may
escape during charging and cause explosions
th ...
Activating/deactivating the residual heat function
It is possible to make use of the residual heat of the engine to continue heating
the stationary vehicle for up to 30 minutes after the engine has been switched off.
The heating time depends on th ...
Overall evaluation
This function is shown if you have stored at
least one lap and stopped the RACETIMER.
Press or
on the steering wheel
to select the AMG menu.
Press the button repeatedly
until the
overa ...