Interchanging the wheels

WARNING
Rotate front and rear wheels only if the tires are of the same dimension.
If your vehicle is equipped with mixed-size tires (different tire dimensions front vs. rear), tire rotation is not possible.

WARNING
Have the tightening torque checked after changing a wheel. Wheels could become loose if not tightened with a torque of 96 lb-ft (130 Nm).
Only use genuine Mercedes-Benz wheel bolts specified for your vehicle's rims.

The wear patterns on the front and rear tires differ, depending on the operating conditions.

Rotate the wheels before a clear wear pattern has formed on the tires. Front tires typically wear more on the shoulders and the rear tires in the center.

If your vehicle's tire configuration allows, you can rotate the wheels according to the intervals in the tire manufacturer's warranty book in your vehicle documents. If this is not available, the tires should then be replaced every 3000 to 6000 miles (5000 to 10,000 km), or earlier if the tire wear requires this. Do not change the direction of wheel rotation.

Clean the contact surfaces of the wheel and the brake disc thoroughly every time a wheel is interchanged. Check the tire pressures.

Information on changing a wheel and mounting the spare wheel.

pressure On vehicles equipped with a tire pressure monitor, electronic components are located in the wheel.
Tire-mounting tools should not be used near the valve. This could damage the electronic components.
Always have the tires changed at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

    See also:

    Checking tire pressure electronically
    Make sure that the SmartKey is in position 2 () in the ignition lock. Press the or button on the steering wheel to select the Service menu. Press the or button to select Tire Pres ...

    MOExtended tires (tires with run-flat properties)
    MOExtended tires (tires with run-flat properties) allow you to continue driving your vehicle even if one or more tires are entirely deflated. MOExtended tires may only be used in conjunction ...

    Removing a CD/DVD
    Press the eject button. The drive ejects the disc. Take the disc out of the slot. If you do not take the disc out of the slot, the drive will draw it in again automatically after a short whi ...