Power washers

WARNING
Do not use power washers with circular-jet nozzles (dirt grinders) to clean your vehicle, in particular the tires. You could otherwise damage the tires and cause an accident.

least Always maintain a distance of at least 11.8 in (30 cm) between the vehicle and the power washer nozzle. Information about the correct distance is available from the equipment manufacturer.
Move the power washer nozzle around when cleaning your vehicle.
Do not aim directly at any of the following:
• tires
• door gaps, roof gaps, joints etc.
• electrical components
• battery
• connectors
• lights
• seals
• trim elements
• ventilation slots
Damaged seals or electrical components can lead to leaks or failures.

    See also:

    Conditions for activation
    RACE START can be activated when: • the doors are closed. • the engine is running and it has reached an operating temperature of approximately 176 °F (80 °C). This is the case when the engine ...

    Adjusting the active multicontour seat
    You can adjust the active multicontour seat using COMAND. If PRE-SAFE® has been activated, the air pressure in the air chambers (the side bolsters of the seat cushion and backrest) of the mu ...

    Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached
    If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved: ► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is ...